Effect of High Temperature and UV Radiation on the Insecticidal Capacity of a Spodoptera frugiperda Nucleopolyhedrovirus Microencapsulated in a Matrix Based on Oxidized Corn Starch.

A multiple nucleopolyhedrovirus native isolate (SfCH32) of Spodoptera frugiperda (J.E. Smith) (Lepidoptera: Noctuidae) was encapsulated by spray-drying in a matrix based on oxidized corn starch without and with a fluorescent brightener. The microcapsules were exposed to UV radiation (365 nm) for 0, 2, 4, and 8 h at 25 °C or temperatures of 35, 40, and 45 °C for 8 h. The data obtained with temperatures 35, 40, and 45 °C were contrasted with those obtained at 25 °C. The microcapsules were evaluated for size, shape, and insecticidal capacity against third instar S. frugiperda larvae under laboratory conditions. The 82-84.2% of the encapsulating matrix, in a dry-weight basis, was recovered as NPV microcapsules of heterogeneous shape and size. The exposure to UV radiation and temperatures reduced significantly the insecticidal capacity of tested viruses; however, such capacity was higher for microencapsulated than for non-microencapsulated viruses. The non-encapsulated virus that had been exposed to 45 °C or maintained at UV radiation for 8 h showed the lowest insecticidal activity at 5th day post-inoculation, with a larvae mortality of 25.3 and 16%, respectively. The fluorescent brightener increased significantly the insecticidal capacity of encapsulated and non-encapsulated viruses, causing a mortality of 100% at that time point, and decreased the median lethal time independently of the incubation temperature and exposure time to radiation. The findings suggested that an encapsulating matrix based on oxidized corn starch might protect the insecticidal capacity of NPV under field conditions.

Physicochemical, Structural, Thermal and Rheological Properties of Flour and Starch Isolated from Avocado Seeds of Landrace and Hass Cultivars.

The objective of this study was to obtain and characterize flours and starches from the avocado seeds of Hass and landrace cultivars. The morphological, physical-chemical, structural, thermal and rheological characteristics were evaluated. The flour yield of the Hass and landrace cultivars was 41.56 to 46.86% (w/w), while for starch, it was 35.47 to 39.57% (w/w) (cv. Hass and landrace, respectively). Scanning electron microscopy (SEM) revealed the presence of oval starch granules and other particles in flour, in contrast to flours, starches showed lower ash, proteins and lipids content. However, the amylose content was higher in starches (42.25-48.2%). Flours showed a higher gelatinization temperature (Tp = 73.17-73.62 °C), and their starches presented greater gelatinization enthalpy (∆Hgel = 11.82-13.43 J/g). All samples showed a B-type diffraction pattern, and the crystallinity was higher in the flours. The rheological analysis (flow curves and viscoelastic tests) evidenced a pseudoplastic (n = 0.28-0.36) behavior in all samples analyzed, but the consistency index (k) was higher in starches. In general, the flours and starches from avocado seeds presented interesting proximal, thermal and functional properties for possible application in food systems, and these findings could contribute to the revaluation of this by-product.

Physicochemical Characterization of Resistant Starch Type-III (RS3) Obtained by Autoclaving Malanga (Xanthosoma sagittifolium) Flour and Corn Starch.

The feasibility of obtaining resistant starch type III (RS3) from malanga flour (Xanthosoma sagittifolium), as an unconventional source of starch, was evaluated using the hydrothermal treatment of autoclaving. The physicochemical characterization of RS3 made from malanga flour was carried out through the evaluation of the chemical composition, color attributes, and thermal properties. In addition, the contents of the total starch, available starch, resistant starch, and retrograded resistant starch were determined by in vitro enzymatic tests. A commercial corn starch sample was used to produce RS3 and utilized to compare all of the analyses. The results showed that native malanga flour behaved differently in most of the evaluations performed, compared to the commercial corn starch. These results could be explained by the presence of minor components that could interfere with the physicochemical and functional properties of the flour; however, the RS3 samples obtained from malanga flour and corn starch were similar in their thermal and morphological features, which may be related to their similarities in the content and molecular weight of amylose, in both of the samples. Furthermore, the yields for obtaining the autoclaved powders from corn starch and malanga flour were similar (≈89%), which showed that the malanga flour is an attractive raw material for obtaining RS3 with adequate yields, to be considered in the subsequent research.

Chitosan Films Obtained from Brachystola magna (Girard) and Its Evaluation on Quality Attributes in Sausages during Storage.

High molecular weight chitosan (≈322 kDa) was obtained from chitin isolated from Brachystola magna (Girard) to produced biodegradable films. Their physicochemical, mechanical and water vapor permeability (WVP) properties were compared against commercial chitosan films with different molecular weights. Brachystola magna chitosan films (CFBM) exhibited similar physicochemical and mechanical characteristics to those of commercial chitosans. The CFBM films presented lower WVP values (10.01 × 10-11 g/m s Pa) than commercial chitosans films (from 16.06 × 10-11 to 64.30 × 10-11 g/m s Pa). Frankfurt-type sausages were covered with chitosan films and stored in refrigerated conditions (4 °C). Their quality attributes (color, weight loss, pH, moisture, texture and lipid oxidation) were evaluated at 0, 5, 10, 15 and 20 days. Sausages covered with CFMB films presented the lowest weight loss (from 1.24% to 2.38%). A higher increase in hardness (from 22.32 N to 30.63 N) was observed in sausages covered with CFMB films. Compared with other films and the control (uncovered sausages), CFMB films delay pH reduction. Moreover, this film presents the lower lipid oxidation level (0.10 malonaldehyde mg/sample kg). Thus, chitosan of B. magna could be a good alternative as packaging material for meat products with high-fat content.

Characterization of insect chitosan films from Tenebrio molitor and Brachystola magna and its comparison with commercial chitosan of different molecular weights.

Insects are considered as alternative sources of chitosan; however, studies about the functional film-forming properties of insect chitosan are scarce. Insect chitosan films were made from Tenebrio molitor and Brachystola magna and were compared with commercial chitosan of different molecular weights (Mw). Mechanical properties (tensile strength, TS; elastic modulus, EM; elongation at break, %E), water vapor permeability (WVP) and physicochemical properties were characterized. The film properties of both commercial and insect chitosan were affected by Mw. Commercial chitosan films showed that at lower Mw, the TS (from 59 to 48 MPa) and EM (from 1471 to 1286 MPa) decreased; whereas WVP (from 2.9 × 10-11 to 3.4 × 10-11 g m-1s-1Pa-1), % E (from 38 to 41%) and solubility (from 30 to 33%) increased. Chitosan insect films showed lower TS and EM, and higher WPV, %E and solubility than commercial films. SEM revealed that chitosan insect films had lower porosity than commercial films. FTIR and X-ray diffraction showed not difference between insect and commercial chitosan films. These results showed that T. molitor and B. magna chitosan films could be used as a packaging material in several food products.

Evaluation of Cooking Quality, Nutritional and Texture Characteristics of Pasta Added with Oat Bran and Apple Flour.

This study reports the effect of the addition of oat bran and apple flour on the cooking quality, digestibility, antioxidant, nutritional and texture characteristics of a spaghetti-type pasta. Pasta samples were prepared by substituting 50% of durum wheat semolina with oat bran (OBP) or apple flour (AFP). AFP presented higher cooking loss and water absorption index than the control pasta prepared with 100% durum wheat semolina (WSP). The supplementation of pasta with oat bran increased the total dietary fiber content (16.43% w/w, dw), while apple flour decreased the protein content (11.16% w/w, dw). There was no significant difference in the resistant starch content among all pasta samples. The pasta samples made with 50/50 durum wheat semolina/oat bran and 50/50 durum wheat semolina/apple flour increased the antioxidant activity by ≈46% and ≈97%, respectively. The OBP and AFP samples had a similar texture to the control pasta. A 50% replacement of durum wheat semolina with oat bran in a pasta formulation decreased the caloric content and digestibility of its starch components. These attributes found in the oat bran pasta and apple flour pasta make them a healthy choice for the diet of people with specific nutritional needs.

Prevalence, typing and phylogenetic analysis of Melissococcus plutonius strains from bee colonies of the State of Chihuahua, Mexico.

European foulbrood (EFB) caused by Melissococcus plutonius is an important bee brood disease but, in Mexico, information about this bacterium is limited. We evaluated the prevalence of typical and atypical strains in beehives of seven apicultural regions of the state of Chihuahua, Mexico. We performed MLST and phylogenetic analysis to characterize the isolates. Prevalence was highest 59%, in the region of Chihuahua, and lowest, 14%, in the regions of Cuauhtémoc and Nuevo Casas Grandes. Typical and atypical strains were identified in hives from all regions; however, in the regions of Parral, Cuauhtémoc and Aldama, the atypical strains were only detected in combination with typical strains. We obtained 81 isolates of M. plutonius and identified seven sequence types, of which three were new types. Additionally, we observed a relation between sequence type and the region where the strain was isolated. Phylogenetic analysis and multilocus sequence typing using goeBURST analysis showed that 97.5% of the isolates correspond to the Clonal Complex (CC) 12 and 2.5% to the CC3. Our work is the first molecular characterization of M. plutonius in Mexico and contributes to global information about the epidemiology of this pathogen.

Codon Optimization of the "Bos Taurus Chymosin" Gene for the Production of Recombinant Chymosin in Pichia pastoris.

Codon optimization of the Bos taurus Chymosin gene (CYM) for its expression in Pichia pastoris was performed in this study. A synthetic CYM gene was designed in silico by replacing codons rarely used by P. pastoris with equivalent nucleotide combinations that codify for the same amino acid but that are more frequently encountered in the genome of P. pastoris. A total of 332 nucleotides were modified to optimize 289 codons. The synthetic CYM gene was cloned into the expression vector pPICZαA and transformed into P. pastoris. The transformed strains were grown in artificial media supplemented with glycerol as a carbon source to increase biomass and then cultured in a similar medium replacing glycerol with methanol as a carbon source to initiate gene induction. Raw extracts of the growth media exhibited milk-clotting activity of 146.11 SU/mL. Produced recombinant chymosin showed coagulant activity from 25 to 50 °C, and within a pH range of 5-6.9, having optimum activity at 35-40 °C, and pH 5.0. These results show that codon optimization is a viable strategy to improve CYM gene expression levels in P. pastoris for the production of recombinant chymosin.